![]() If water does flow through the supply line, you'll likely need to replace the water inlet valve because it's not opening to allow water to flow into the reservoir. If no water flows through the end of the supply line, have a plumber fix the water supply going to the ice maker. Briefly open the water supply cut-off valve and check for water flow from the end of the water supply line. Disconnect the water supply line from the ice maker and place the end of the water supply line in a container. To check the water supply, unplug the ice maker and shut off the water supply cut-off valve. If the reservoir is empty, check the water supply going to the ice maker. If the evaporator plate is dry and the water reservoir is full, then the recirculation pump is likely bad. ![]() If the ice maker doesn't start making ice, check the evaporator plate. A power surge through the electrical supply line to the ice maker can lock up the control board, so reset the control board by unplugging the ice maker for one minute, then restoring electrical power. ![]() When the ice maker runs but doesn't make any ice, a bad electronic control board, failed water supply, broken recirculation pump, sealed system failure or broken cutting grid could be causing the problem.Ī faulty electronic control board can prevent the ice maker from making any ice.
0 Comments
Leave a Reply. |